Select cars to narrow search
dont search for 599cc fortwo modsdont search for 698cc fortwo modsdont search for 999cc fortwo modsdont search for roadster modsdont search for 453 smart modsdont search for forfour mods

Electrical guides and mods

Heater Control Lighting

The heater control lights aren't very well lit and colour coding with LEDs isn't ideal. Let's check out the problems and alternatives.

Modification Details




Should The Heater Markers Light Up?

Yes they should but quite often the bulb blows and people question whether they illuminated before.

Where Is The Bulb?

While not immediately obvious, the bulb is actually fitted inderneath the safety cluster triangle.
Follow
this guide to remove the triangle from the dash so you can access the bulb.

You will find a single 509T twist fit bulb in the centre. Replace with another bulb and test.

Can I Fit An LED Instead?

You can but don't expect it to look very good, this is because of
the light guide used to distribute light around the heater symbols.

The Problem With Light Guides

The initial problem is that the light guide collects light from the side of the bulb.
Standard bulbs illuminate in a very wide beam so light is collected with no problems.

A standard LED illuminates forward so the light guide has problems collecting light.
This means that the collected light is only a fraction of that produced by the LED.

Light guides are very inefficient at carrying light around corners,you can lose
30% of the light through a 90 degree bend, the light guide has two each side.

The final deflection that lights the heater controls will only use about 20% of what it is given.

Because of the pick up point of the light guide and it's inefficiency to carry light,
you can only expect to see about 2% of the light created by the LED.

So What Is The Solution?

You have a few option to take a look at:



Altered LED Designs

This is a standard LED, they often produce a narrow beam to increase the output.
When used, they usually create a bright spot with no lighting at the side.




The new style flat top LEDs create a slightly wider beam that isn't affected by the done lens.
They create a larger bright spot with no side lighting.




The heater control light guide picks up light from 2 opposite sides so the above LEDs
would not be suitable for usage in that area although some lighting may occur.

What we need is an LED that will emit some side lighting,
currently that only leaves us with the new 'inverted cone' design.



Although the inverted cone design will give better side lighting, it's not perfect.
To get the best from an LED you have to modify it yourself.

If you got a standard or flat top LED and cut a V shaped valley into the top
and then glued a tiny bit of tin foil into the V, it would reflect all the light sideways.



The EL Wire Method

Attention

The rest of the information held in this guide is locked to members of Evilution only, you can login below or click this link to find out more.

Enter your login credentials here

Email:
Password:



Click if Info Helpful

Contact us about mod
Cookies
Terms and Conditions
Site Disclaimer

© Copyright 2013, all rights reserved.