Select cars to narrow search
dont search for 599cc fortwo modsdont search for 698cc fortwo modsdont search for 999cc fortwo modsinclude roadster modsdont search for 453 smart modsdont search for forfour mods

54bhp CDI Exhaust Temp Sensors

Modification Details

54bhp CDI 451 Exhaust And Turbo Temperature Sensors

The turbo temperature sensor and the DPF temperature sensors are fairly common failures on the 54bhp diesel 451
fortwo. The issue is that the symptoms of a failed temperature sensor were very similar to a failed DPF pressure
sensor failure. Thankfully, the temperature sensors are very easy to test to ensure they're functioning correctly.

Getting To The Sensors

Simple remove the rear panels. Then look at the turbo to find the 1st sensor.

Then loom at the exhaust box to find the 2nd sensor.

Thankfully, you don't really need to remove them to test them.

The electrical connectors can be seen underneath the engine, on the left side, behind the drive shaft.
Disconnect them both and find your trusty multimeter.

Bench Testing The Sensors

Leave the car unused until everything is as cold as the air temperature.

Set your multimeter to read ohms. If your test probes aren't thin enough, use wire or
pins pushed into the connector so you can make good contact with both terminals.

At 18 degrees C (the normal temperature of my house), the sensor read 216 ohms.

However, when put in freshly boiled water, the multimeter showed 270 ohms.

The important thing is that both sensors read approximately the same amperage.
That's because they are the same sensor at the same temperature. It's just the housing is different lengths,

Click if Info Helpful

Contact us about mod
Terms and Conditions
Site Disclaimer

© Copyright 2013, all rights reserved.