Mod DetailsPremiumNo Difficulty Mod ID1653 For Linkhttps://www.evilution.co.uk/mod/451-heater-controller-disassembly.htm Copy to Clipboard
This is the last and hardest part to change the LEDs on because it’s awkward to open. Remove the heater controller by following the 1st part of this guide. Set the fan speed to setting 2 and the heat to setting 22. (This lines up internal tabs).
Look on each side and you will see 2 rectangle openings. Place a screwdriver in each side and lever the tabs towards the centre. You can then pull the dials off. Or you can just lever the entire heater controller disc off and the clips will let go.
Here you can see the tabs below and the holes above it.